The resistance picture in 2026
Annual monitoring by Rothamsted Research ↗ and AHDB ↗ now tracks hundreds of Zymoseptoria tritici isolates collected from UK wheat fields each season. The 2024 and 2025 surveys confirmed that isolates carrying multiple SDHI resistance mutations are present at meaningful frequency in many regions — particularly in eastern England and the Rhine valley.
The Fungicide Resistance Action Committee (FRAC) ↗ now lists Z. tritici SDHI resistance as confirmed and at high risk of spreading further. The practical implication is reduced field efficacy from SDHI-only programmes — especially at reduced doses.
How resistance develops
Resistance to SDHIs in Z. tritici is driven by point mutations in the genes encoding the four subunits of succinate dehydrogenase (complex II). The B, C and D subunit mutations are most commonly detected. Crucially, multiple mutations can accumulate in the same isolate, increasing the resistance level step by step.
High fungicide selection pressure — particularly solo SDHI use at T1 and T2 — accelerates selection of resistant genotypes. The ERA-CAPS ISENSE project ↗ provided the population genetics framework that now underpins current resistance management guidelines.
Azole sensitivity also declining
Azole (DMI) sensitivity in Z. tritici has been eroding since the 1990s due to CYP51 mutations combined with efflux pump overexpression. While azoles remain partially effective, their contribution to a programme should be treated as supporting rather than primary. Shaw et al., 2020 (Nature Scientific Reports) ↗ modelled the quantitative relationship between CYP51 mutations and field efficacy.
Practical programme principles
The core stewardship principles recommended by AHDB and the Crop Protection Network ↗ for managing SDHI resistance in wheat are:
- Mix modes of action at every application — SDHI + azole + multisite (e.g. chlorothalonil where available, or folpet)
- Do not use the same SDHI active at both T1 and T2 in the same season
- Maintain full or near-full doses — sub-doses increase selection pressure without proportionally reducing yield loss
- Choose varieties with high septoria resistance ratings — reducing reliance on chemistry
- Delay drilling where rotation and risk assessment allow
Variety resistance ratings
The most powerful lever available is variety selection. The AHDB Recommended Lists ↗ score varieties 1–9 for septoria tritici blotch resistance. At score 7 or above, untreated yield losses are substantially lower and a two-spray programme may be sufficient in moderate seasons. At score 4–5, three sprays may be needed even in average years.
The KWS variety selector ↗ and Limagrain UK ↗ both provide disease resistance data for their varieties alongside the AHDB figures.
What to watch this season
AHDB's disease management hub ↗ publishes in-season fungicide performance updates. If SDHI efficacy drops below expected levels in your T2 application, recording this and reporting through the AHDB monitoring scheme helps track regional resistance spread.