Markets

Nitrogen fertiliser market update: spring 2028 prices and supply outlook

Urea and ammonium nitrate prices have eased from their winter peak — is now the time to secure spring requirements or wait for further falls?

Spring 2028 fertiliser price comparison

Product£/tonne£/kg Nvs 2027Notes
Ammonium nitrate (34.5%) £290–310/t £0.84–0.90/kg N -12% UK spot price; bulk delivered farm
Urea (46%N) £270–290/t £0.59–0.63/kg N -8% Include NBPT inhibitor cost for effective comparison with AN
Protected urea (NBPT) £320–345/t £0.70–0.75/kg N -5% Regulatory pressure increasing uptake; winter discounts now ending
UAN (32%N liquid) £220–240/t £0.69–0.75/kg N -10% Variable rate spreading advantages; transport cost sensitive
Sulphate of ammonia (21%N) £240–260/t £1.14–1.24/kg N +2% S premium justifies cost for OSR, grassland

Market context: what is driving prices in 2028

The easing from winter 2027–28 peaks is primarily driven by stable European natural gas prices — the key cost driver for European ammonia and ammonium nitrate production — alongside higher-than-expected Chinese urea exports in Q4 2027 and Q1 2028. The TTF gas benchmark is trading at approximately €37/MWh, significantly below the crisis peak of €300/MWh in 2022 but still above the pre-2021 norm of €15–20/MWh that underpinned the lower fertiliser prices of 2018–2020.

For UK arable farmers, the key comparison is the current cost per kg of nutrient applied versus the marginal value of yield response. At current prices, the economic optimum N rate for milling wheat with current grain prices is broadly unchanged from the 2027 AHDB recommendations. See the spring nitrogen application guide and nitrogen timing in cereals guide for the agronomic rate and timing decisions.

Protected urea: the regulatory direction

The UK government's Clean Air Strategy continues to drive regulatory pressure towards low-emission urea products. While a formal mandate for NBPT-treated or urease-inhibitor-coated urea has not yet been confirmed for all situations, Farming Rules for Water and the Reduction of Ammonia Emissions from Agriculture consultation signal the direction. Growers adopting protected urea now are positioned well for future compliance requirements. See the nitrogen use efficiency and denitrification glossary entries for the nitrogen loss pathway context.

Planning spring nitrogen applications

Spring nitrogen planning should start from the RB209 nutrient management recommendations, adjusted for soil mineral nitrogen (SMN) test results where available and soil nitrogen supply (SNS) estimates. The spring nitrogen application guide covers the calculation of total rate and split programme. Don't forget sulphur: with near-universal S deficiency on UK arable soils, including an S source in the first spring application is essential. See the sulphur glossary entry for crop requirements by species.

Frequently asked questions

Is it better to buy nitrogen now or wait for spring prices to fall further?
The forward price curve for ammonium nitrate and urea in early 2028 is broadly flat to slightly downward — reflecting stable European gas prices (the primary production cost) and adequate global urea supply from the Middle East and Black Sea. The case for buying now: prices have eased significantly from the winter peak; supply disruption risk is low but not zero; locking in spring requirements removes market exposure during the critical application window. The case for waiting: gas prices remain above long-term average; Chinese urea export volumes have been higher than expected, adding global supply; further modest price falls are possible through March. A pragmatic approach for most farms is to cover 50–60% of spring requirements now and leave the remainder at spot risk. See the fertiliser price outlook 2027 article for the historical price context.
What is the cost difference between ammonium nitrate and protected urea?
At current (Feb 2028) prices, ammonium nitrate (AN) at £0.87/kg N and protected urea (NBPT urea) at £0.72/kg N shows a £0.15/kg N cost advantage for protected urea. On a 200 kg N/ha wheat programme, this equates to approximately £30/ha lower nutrient cost for urea. Against this saving must be weighed: (1) the agronomic performance — protected urea performs comparably to AN in most UK trials, but with greater volatilisation risk in warm, dry conditions on alkaline soils even with NBPT; (2) the machinery requirement — granular urea and AN have similar spreading characteristics, but liquid UAN requires different application equipment; (3) the regulatory direction — the UK government has indicated intent to mandate low-emission urea products (NBPT or DMPP) on vulnerable soils, making protected urea an increasingly standard product. See the spring nitrogen application guide.
What is driving nitrogen fertiliser prices in 2028?
Nitrogen fertiliser prices in early 2028 are primarily driven by: (1) European natural gas prices — gas represents 70–80% of the marginal production cost for European ammonia/AN; EU gas prices have stabilised at approximately €35–40/MWh (TTF benchmark), significantly below the 2022 crisis peak of €300/MWh but above the pre-2021 average of €15–20/MWh; (2) Urea supply dynamics — Chinese export policy (periodic export bans or quotas) is the most significant swing factor in global urea markets; China has been a net exporter in early 2028; (3) Currency — a stronger GBP/EUR makes imported AN cheaper in sterling terms; (4) Shipping and logistics — Red Sea disruption in 2023–24 has partially normalised. The price floor is set by the marginal cost of European production. See Yara UK market commentary ↗ for current analysis.
How do I calculate the true cost per kg of nitrogen across different products?
The true cost comparison requires converting product price to cost per kg of nutrient applied to the crop: Cost per kg N = Product price (£/t) ÷ (N% × 10). Examples: AN 34.5%N at £300/t = £300 ÷ 345 = £0.87/kg N. Urea 46%N at £280/t = £280 ÷ 460 = £0.61/kg N. But this comparison must then be adjusted for utilisation efficiency: urea without NBPT may lose 5–15% N as ammonia volatilisation in unfavourable conditions (warm, alkaline, dry soil surface after application). An effective utilisation adjustment: multiply the cost per kg N by a utilisation factor (AN = 1.0; protected urea = 1.02–1.05; unprotected urea = 0.85–0.95 in UK conditions). Use this to make a like-for-like comparison. See the nitrogen use efficiency glossary entry for the underlying efficiency concepts.
What sulphur source should I use alongside my nitrogen this spring?
Sulphur deficiency is now near-universal on UK arable soils following the reduction in atmospheric S deposition since the 1980s. The main spring S application options are: (1) Ammonium sulphate (21%N + 60%SO₃) — well-matched product for spring but higher N:S ratio; cost effective where both N and S are needed; (2) Liquid nitrogen-sulphur (N+S solutions) — flexible rate application; commonly used in precision farming; (3) Kieserite (MgSO₄) — supplies both Mg and S; useful where soil Mg is low; (4) Elemental sulphur — slow-release, requires microbial oxidation to sulphate before plant availability; not suitable for single-season application. For most cereals, a spring application of 25–50 kg SO₃/ha alongside the first N split is the standard approach. For OSR, 50–75 kg SO₃/ha is required — see the OSR nitrogen management article. See also the sulphur glossary entry.