Crop preset
Seed rate 169 kg / ha
Total to order 1690 kg
Show formula
seed rate (kg/ha) = plants/m² × TGW(g) ÷ 100 ÷ germination% ÷ emergence%
total order (kg) = seed rate × area (ha)

Starting values are examples. Use your seed certificate figures.

About this calculation

The seed rate formula divides the desired number of established plants by the probability of each seed becoming a plant. That probability is germination % × field emergence %, expressed as fractions. TGW converts from seeds per m² to kg/ha (1 ha = 10,000 m²).

Preset values for germination and emergence are typical industry starting points. Always use the germination % from your seed certificate and adjust field emergence for actual conditions — seedbed quality, soil temperature below 7 °C and slug pressure can all reduce emergence below 80 %.

Formula source: AHDB seed rates guidance and NIAB seed rate methodology.

Frequently asked questions

What is TGW and where do I find it?
Thousand Grain Weight (TGW) is the weight in grams of 1,000 seeds of a variety. It is printed on your seed certificate (usually 35–55 g for wheat). Using the actual figure from your batch gives a more accurate seed rate than a default. NIAB ↗ publishes variety-level TGW data for UK certified seed.
What target plant population should I use for winter wheat?
AHDB guidance ↗ recommends 200–400 plants/m² for winter wheat depending on drilling date and variety tillering ability. Later drilling (October+) generally warrants higher populations (300–400/m²) to compensate for reduced tiller development. The AHDB Wheat Growth Guide ↗ covers plant population targets by growth stage.
How is field emergence different from germination?
Germination (%) is measured in a controlled lab environment and listed on the seed certificate. Field emergence (%) is lower — it accounts for losses from soil conditions, seedbed quality, slug pressure and drilling depth. Typical field emergence for cereals is 80–90 % under good conditions. See UMN Extension — Germination and seedling vigour ↗ for a detailed breakdown.
Why is my seed rate in kg/ha much lower for OSR than wheat?
Oilseed rape seeds are much lighter (TGW ~3–5 g vs ~40–50 g for wheat) and target populations are far lower (40–60 plants/m² vs 250–350/m²). This means typical OSR seed rates are 3–5 kg/ha vs 150–200 kg/ha for wheat. Farmers Weekly ↗ has a worked example comparing cereal and OSR seed rates.
Should I add a safety margin to my order?
Yes — most agronomists recommend ordering 5–10 % more than the calculated total to account for headlands, calibration losses and any resowing. The tool gives the theoretical requirement; add your buffer separately. The Crop Protection Network ↗ covers field-loss factors in detail.
How do I calculate seed rate — what is the formula?
The calculation of seed rate uses this formula: seed rate (kg/ha) = target plants/m² × TGW ÷ 100 ÷ (germination % × field emergence %). For example, winter wheat at 300 plants/m², TGW 45 g, 95 % germination, 85 % field emergence gives: 300 × 45 ÷ 100 ÷ (0.95 × 0.85) = 167 kg/ha. The seeding rate calculator on this page handles the arithmetic automatically. Always use the germination percentage from your own seed certificate for accuracy. See the AHDB seed rate guide ↗ for crop-specific seed rate guidance.
Does the calculator account for seed treatments?
No — seed treatments (fungicide, insecticide pelleting) affect seed weight but the effect is negligible (<1 %) for standard cereal dressings. For polymer-coated seeds such as maize, use the dressed seed TGW from the supplier. See AHDB seed treatments for cereals ↗ for an overview of available dressings.