Water

Available water capacity

Abbreviation: AWC · Also: plant available water, PAW · Unit: mm/m

The amount of water held in a soil that is accessible to plant roots — the difference between field capacity and the permanent wilting point.

AWC (mm/m) = (Field capacity % − Permanent wilting point %) × bulk density × 1000. Soils with high AWC buffer crops against drought stress between rainfall events. Sandy soils hold 50–80 mm/m; loams 100–150 mm/m; clay loams 130–170 mm/m. Increasing soil organic matter is the most effective management lever for improving AWC.

Available water capacity by soil texture

TextureAWCField cap.Wilt pt.Implications
Sand 50–80 mm/m ~10% ~3% Low AWC — drought stress likely in extended dry periods
Sandy loam 80–110 mm/m ~20% ~8% Moderate AWC — irrigation often justified for high-value crops
Loam 100–150 mm/m ~30% ~14% Good AWC — most balanced texture class
Silt loam 130–170 mm/m ~35% ~16% High AWC — good water supply but prone to surface capping
Clay loam 130–170 mm/m ~40% ~20% High AWC but slow drainage and narrow workability window
Clay 100–140 mm/m ~50% ~28% Despite high field capacity, clay can have lower AWC than loam

Values are typical ranges — actual AWC varies with organic matter content, structure and compaction. FC and PWP are approximate volumetric water content percentages.

Why AWC matters in crop production

Available water capacity is the primary determinant of a soil's ability to supply water to crops between rainfall or irrigation events. In practical terms, a loam soil with AWC of 150 mm/m and a rooting depth of 0.8 m holds 120 mm of plant-available water — equivalent to roughly 2–3 weeks of crop water demand in summer before stress begins. A sand with AWC of 70 mm/m and the same rooting depth holds only 56 mm — perhaps 1 week's supply.

This difference is the single most important soil factor for drought risk. In the UK, a 2-week dry spell in June–July at peak crop water use can remove the entire buffer of a shallow sandy soil, causing significant yield reduction in cereals, quality defects in potatoes and water stress in maize at the most sensitive stage. See the effective rainfall glossary entry and the irrigation scheduling guide for how AWC integrates with weather-based water budget calculations.

Improving AWC through soil management

Soil organic matter is the primary management lever for improving AWC. Research from Rothamsted's long-term field experiments (Broadbalk, Hoosfield) and from the Soil Health Institute ↗ confirms a consistent positive relationship between SOM and AWC across all texture classes. Practical interventions include:

  • Cover crops: root exudates and above-ground biomass add organic matter — see the cover crop species selection guide
  • Organic manures: regular farmyard manure or compost applications build SOM consistently over time
  • Reduced tillage: less tillage reduces SOM oxidation rates — retained SOM contributes to AWC
  • Compaction alleviation: restoring rooting depth effectively multiplies the AWC benefit — see the compaction assessment guide

The soil organic matter guide covers the management of SOM in detail, including the expected timescale for building AWC through the above practices. For the measurement foundation, see the soil sampling and testing guide.

AWC and soil management planning

AWC data is available for English and Welsh soils from the LANDIS Soilscapes dataset ↗. The Soil Health Institute ↗ and ISRIC World Soil Information ↗ provide global soil property data including AWC estimates for European agricultural soils.

Frequently asked questions

What is the difference between field capacity and permanent wilting point?
Field capacity (FC) is the soil moisture content retained after free drainage has stopped — typically 24–48 hours after thorough wetting. Water above FC is held loosely in macropores and drains under gravity. Permanent wilting point (PWP) is the moisture content at which plants can no longer extract water from the soil against matric potential — roots lose turgor and the plant wilts permanently. AWC is the difference between these two points: the water held in mesopores and micropores between FC and PWP. Soil Health Institute resources ↗ cover soil physical properties and their management in detail.
How does organic matter improve available water capacity?
Soil organic matter improves AWC through two mechanisms: (1) direct water retention — organic matter particles can absorb 2–10× their weight in water, held at tensions accessible to plant roots; (2) soil structure improvement — organic matter stabilises soil aggregates, creating mesopore spaces that hold water at matric potentials accessible to roots. Research suggests each 1% increase in SOM increases AWC by approximately 1.5–2.5 mm/100 mm soil (15–25 mm/m). Over a 1 m rooting depth, this could represent 15–25 mm additional buffer against drought. See the soil organic matter guide for management approaches to building SOM.
How is AWC used in irrigation scheduling?
Irrigation scheduling uses AWC to calculate the soil moisture deficit (SMD) — the amount of water needed to refill the soil to field capacity. The crop is allowed to deplete a proportion of the AWC before irrigation is triggered (the manageable allowable deficit, MAD). Sensitive crops (e.g. lettuce, onions) are irrigated at 25–40% AWC depletion; robust crops (e.g. winter wheat) may tolerate 50–70% depletion. AHDB irrigation scheduling tools ↗ use AWC as the primary soil input. See the irrigation scheduling guide for the full SMD calculation framework.
Which crops are most affected by low available water capacity soils?
Crops most affected by low AWC soils include: potatoes — irregular moisture supply causes growth checks, hollow heart and secondary growth; sugar beet — water stress during bulking significantly reduces yield; field vegetables (carrots, parsnips, leeks) — quality defects in dry conditions; maize — exceptionally sensitive during tasselling and early grain fill. Cereals on low AWC soils are often droughted in May–June if the growing season is dry, reducing ear size and grain number. See the irrigation scheduling guide and the effective rainfall glossary entry for water budget planning.
Can I measure available water capacity in the field?
AWC is typically estimated from particle size analysis (soil texture) and organic matter content using published pedotransfer functions. Direct measurement is possible using soil moisture sensors (capacitance probes, TDR or neutron probes) that can measure actual moisture content at FC and at stress thresholds — but requires calibration for each soil. For most farm purposes, a published AWC figure from a soil survey map (LANDIS UK ↗ provides the Soilscapes AWC data for England and Wales), combined with a local soil texture assessment from a soil sampling test, provides an adequate basis for irrigation scheduling and drought risk assessment.
How does rooting depth interact with available water capacity?
Total plant-available water = AWC (mm/m) × rooting depth (m). Crops with deep rooting can access water stored in subsoil layers that shallow-rooted crops cannot reach. This makes rooting depth a critical modifier of effective AWC. Compaction restricts rooting depth — a soil compaction pan at 25 cm effectively limits the rooting depth and therefore the total water reservoir available to the crop, regardless of the AWC in the deeper profile. See the rooting depth glossary entry and the soil compaction assessment guide for the management connection.