Glossary

Harvest Index

HI · dimensionless ratio (0–1)

The harvest index definition: the proportion of above-ground plant biomass that ends up as harvestable economic yield (grain, seed or tuber). A value of 0.50 means half of total above-ground dry matter is in the grain at maturity. The harvest index formula: HI = grain dry weight / total above-ground dry weight.

HI = grain dry weight (t/ha) ÷ total above-ground dry weight (t/ha)

Typical harvest index by crop

Crop Typical range Representative value
Winter wheat 0.45–0.55 0.50
Winter barley 0.40–0.52 0.47
Oilseed rape 0.25–0.35 0.30
Maize (grain) 0.45–0.55 0.50
Potato 0.65–0.80 0.75

Sources: FAO Crop Yield Gap Analysis ↗, Fischer & Edmeades, Crop Science ↗, AHDB Wheat Growth Guide ↗

Why HI matters for yield

Total biomass production is relatively similar between varieties of the same crop. HI is therefore the primary determinant of grain yield differences. Raising HI is how plant breeders increased wheat yields through the 20th century — see Borlaug Nobel lecture ↗.

Lodging and HI

Lodging reduces HI significantly — lodged stems cannot translocate assimilates efficiently to the grain. Maintaining stem strength through variety choice, moderate nitrogen and plant growth regulators protects HI. AHDB lodging management ↗ covers the key risk factors.

HI in climate stress

Drought and heat stress during grain fill reduce grain weight without proportionally reducing straw biomass, lowering HI. Field Crops Research ↗ and MDPI Agronomy ↗ cover HI under climate stress scenarios.

Frequently asked questions

What is harvest index and how is it calculated?
Harvest index (HI) is the ratio of grain (or economic yield) to total above-ground biomass at maturity: HI = grain dry weight ÷ total above-ground dry weight. A wheat crop producing 8 t/ha grain with 16 t/ha total biomass has a HI of 0.50. ScienceDirect — Harvest Index ↗ provides a comprehensive overview.
Why did modern varieties improve harvest index so dramatically?
The Green Revolution of the 1960s–1970s produced semi-dwarf wheat varieties with shorter, stronger straw. Shorter straw diverts fewer assimilates into structural tissue and more into grain, raising HI from ~0.35 in tall varieties to ~0.50 in modern semi-dwarfs. Norman Borlaug's Nobel lecture ↗ describes the original selection rationale.
Is there a maximum achievable harvest index for wheat?
Theoretical maximum HI for wheat is estimated at ~0.62, based on the minimum structural biomass needed to support the crop. Current elite varieties are at ~0.50–0.55. Fischer & Edmeades (2010), Crop Science ↗ discuss the physiological ceiling and routes to further improvement.
What agronomic practices affect harvest index?
Lodging dramatically reduces HI by diverting assimilates to structural recovery rather than grain fill. Drought during grain fill restricts grain weight. Excessive nitrogen promotes biomass over grain, lowering HI. AHDB Wheat Growth Guide ↗ covers the agronomic levers affecting HI.
How does harvest index relate to straw yield?
If you know your grain yield and HI, you can estimate straw yield: straw yield = grain yield × (1/HI − 1). At HI 0.50 and 8 t/ha grain, straw yield ≈ 8 t/ha. NNFCC crop factsheets ↗ include straw yield estimates for common UK arable crops.
Why is harvest index lower for oilseed rape than wheat?
OSR produces a large vegetative biomass (stem, leaves, pods) relative to its seed yield. Oil-rich seeds require more assimilate per unit mass than starch-dominated cereal grain. Matthes & Elbaum (2016), Field Crops Research ↗ analysed OSR source-sink dynamics and the limits on HI improvement.