Why pH is the first thing to fix
Soil liming is the most cost-effective soil improvement on most arable farms. Soil pH controls nutrient availability for every crop you grow — it is not just one factor, it amplifies or suppresses the effect of every other soil management action. Applying phosphate to a pH 5.0 soil achieves a fraction of the response you would get at pH 6.5. Understanding your soil lime requirement calculator output and matching agricultural lime application rates to your soil type is the foundation of liming soils effectively.
Proper pH management also affects soil water potential and available water content, since nutrient uptake depends on root activity in well-structured, correctly limed soils. The Defra farming guidance and FAO Soils Portal both confirm that correcting soil acidity is the single highest-return agronomic investment for most temperate arable systems.
DAERA (Northern Ireland) reports that soil acidity affects 40–50 % of global arable land, making liming one of the highest-return agronomic investments across most farm systems.
Step 1 — Test your soil
A soil pH test is the starting point. Take a composite sample from at least 25 soil cores per field (or management zone), to a depth of 15 cm. An accredited laboratory test costs approximately £5–15 per sample and returns:
- Current pH
- Lime requirement in t/ha to reach your target pH
- Soil buffer capacity (how much lime is needed per unit pH change)
Michigan State University Extension's guide to soil acidity and lime covers sampling protocols, lab methods and interpreting your results.
Step 2 — Set your pH target
pH targets differ by crop and soil type. The AHDB RB209 guide recommends pH 6.5 for continuous arable cropping on mineral soils, with a management target of 6.7 to allow for natural acidification between applications.
Potatoes are an exception: the optimum pH for potatoes is 5.0–6.0 to suppress common scab — significantly lower than other arable crops. Fields in potato rotations should not be limed to the same target as cereal-dominant rotations.
Step 3 — Select your lime product
Lime products are rated by Neutralising Value (NV) — the percentage equivalent of pure calcium carbonate (CaCO3). Pure calcium carbonate has NV = 100. Most ground limestone products have NV of 50–55 %. Magnesian limestone (dolomite) has similar NV but also supplies magnesium.
Finer particles react faster. A product with 40 % passing 150 microns will raise pH measurably within one season; coarser products may take two. The Agricultural Lime Association guide explains how to compare products by NV and fineness.
Step 4 — Apply and incorporate
Apply lime at least three months before the target crop is sown — ideally in the previous season. Incorporate into the seedbed by ploughing or cultivation to 15–20 cm depth for the fastest, most even pH change.
On grassland or no-till systems, surface application raises pH from the top down — this is slower but still beneficial. Do not apply more than 7.5 t/ha in a single application; split large requirements across two applications in successive seasons.
Step 5 — Confirm and maintain
Re-test at your next routine sampling interval (3–5 years). On intensively managed arable land with high nitrogen inputs, pH can drop by 0.2–0.3 units per year. Maintenance liming — smaller applications every few years — is more efficient than correcting a large deficit.
Oregon State Extension and University of Minnesota Extension both publish freely available guides on lime requirement calculation, application rates and timing for a range of soil types.