pH correction

Estimated lime requirement 2.6 t / ha To raise pH from 5.8 to 6.5 on loam / silt loam soil. Ground limestone at ~55 % NV.

NPK nutrient index

Enter the index from your soil report (AHDB 0–4 scale)

Low
Adequate
Adequate

Index 0 = deficient, 1 = low, 2 = adequate, 3 = high, 4 = excess. Refer to your full soil report and AHDB RB209 for crop-specific recommendations.

Lime requirement is an estimate only — ±20 % accuracy without a buffered lab test. Always confirm with an accredited soil test before purchasing lime.

About the estimates

Lime requirement is estimated using the formula: lime (t/ha) = pH gap × 3.75 × soil factor. The 3.75 base rate assumes a ground limestone at ~55 % Neutralising Value (NV) on a medium loam. Soil texture factors (0.7–1.6) approximate the buffering effect of different soils.

This is a planning estimate — accuracy is ±20–30 % without a buffered soil test. A buffered pH test (e.g. Adams-Evans or SMP buffer method) removes much of this uncertainty and is recommended before large liming investments. Reference: AHDB RB209, MSU Extension liming guide.

NPK indices follow the AHDB RB209 0–4 scale used across England, Wales and Scotland. Index 2 is the maintenance target for P and K on most soils. Your crop-specific recommendations require consulting the full RB209 tables.

Frequently asked questions

How accurate is the lime requirement estimate?
The estimate uses a simplified formula (~3.75 t/ha per pH unit on loam, adjusted for soil texture). Accuracy is typically ±20–30 %. A buffered pH test (Mehlich or SMP buffer) from an accredited lab gives a much more precise result. See UMN Extension — Soil pH and liming ↗ for an explanation of buffer pH methods, and always confirm before ordering lime.
What is the AHDB NPK index scale?
AHDB RB209 ↗ uses a 0–4 index: 0 = deficient, 1 = low, 2 = adequate, 3 = high, 4 = excess. Index 2 is the maintenance target for most crops for P and K. For N, the index depends on previous crop — a legume or ploughed grass ley raises the N index. The Defra Fertiliser Manual ↗ is the formal published version.
What does the soil texture factor affect?
Heavier soils (clay) have higher cation exchange capacity (CEC) and buffer pH changes more strongly — they need more lime per pH unit. Sandy soils have low CEC and respond faster but the effect is less durable. Soil Association — Soil health ↗ has a practical introduction to CEC and pH buffering.
At what pH should I lime for winter wheat?
AHDB RB209 ↗ recommends pH 6.5 for most cereals on mineral soils. Below pH 6.0, aluminium and manganese become increasingly available and toxic to roots. MSU Extension ↗ describes aluminium toxicity and its effects on root architecture in detail.
Why does potato have a lower pH target (5.5)?
The main reason is scab control. Common scab (Streptomyces scabies) is suppressed below pH 5.5. Liming to a higher pH increases scab risk. UMN Extension — Common scab of potato ↗ explains the soil pH–scab relationship in detail.
How often should I take a soil test?
AHDB ↗ recommends testing every 3–5 years on arable land, or every 3 years on grassland. Test before liming or major rotational changes. DAERA NI — Soil sampling guidance ↗ covers sampling methodology and frequency in detail.