Season

Maize silage quality 2028: dry matter, starch and ME results from early clamp analysis

First clamp analysis data from harvest 2028 shows above-average starch with unusually high dry matter in the East. How to adjust feeding rates and ration formulation when quality deviates from target.

2028 clamp analysis: the headline numbers

Early composite clamp samples submitted to NIRS analysis during October 2028 show a consistent pattern across the eastern counties: mean dry matter of 34–37%, significantly above the 28–32% typical of the previous five seasons. Starch content is running at 31–36% DM — at the upper end of target range, reflecting good grain fill from high GDD accumulation. Metabolisable energy values are strong at 10.8–11.3 MJ/kg DM. The quality picture is genuinely good for energy content — the management challenge is the high dry matter, which creates fermentation and aerobic stability risks that require careful handling.

Western and northern counties, where August was cooler and wetter, are showing more typical DM values of 28–32% and similar starch levels. The quality variation between East and West is unusually pronounced in 2028 — farms drawing on both eastern arable-grown and western/northern specialist crops will need to blend or manage separately. See the maize DM forecast 2028 article for the season tracking context and the maize harvest management guide for harvest readiness decisions.

Fermentation and aerobic stability in high-DM maize

High-DM maize (above 35%) presents two specific challenges: (1) Incomplete fermentation — drier silage has reduced water activity, which slows lactic acid bacteria growth and may leave pH above 4.0 after 6 weeks. Clamps at DM >35% should have pH tested before feeding begins; target pH <4.2; (2) Aerobic instability — when the clamp face is exposed to air, yeasts in high-starch silage consume fermentation products and generate heat, reducing palatability and energy content. The practical response: advance the clamp face at least 20 cm per day in high-starch silage; consider a propionic acid face spray to suppress yeast activity; seal any unused face area overnight.

Ration formulation guidance for 2028 maize

Dairy nutritionists advising on 2028 maize silage rations should prioritise requesting NIRS starch digestibility (NDFD at 30h or starch digestibility at 7h) alongside the standard DM/ME/NDF analysis. Freshly harvested high-DM maize often has lower rumen starch digestibility than expected from its starch content — partly because of dry grain processing in high-DM crops and partly because fermentation breakdown of the starch matrix takes time. Rations formulated in November/December with fresh 2028 maize may need revising in February/March as starch digestibility increases. See the growing degree days glossary entry for the crop development model driving 2028's unusual season.

Frequently asked questions

What are the target quality parameters for whole-crop maize silage?
Target quality parameters for whole-crop maize silage at clamp: Dry matter (DM): 28–35% — below 28%, excess effluent and poor aerobic stability; above 35%, packing difficulty and heating risk; Starch: 28–35% DM — starch is the primary energy source for dairy cows; drives milk from forage; Metabolisable energy (ME): 10.5–11.5 MJ/kg DM — below 10.5 MJ/kg DM indicates poor grain fill or late harvest; Neutral detergent fibre (NDF): 38–44% DM — structural fibre for rumen function; pH: 3.8–4.0 after fermentation (typically 6 weeks minimum before feeding). The 2028 clamp data shows mean DM of 34–37% across eastern counties — above the upper target, driven by the warm, dry August–September. High DM maize is drier to pack and more prone to aerobic instability once the clamp is opened. See the maize harvest management guide for harvest DM timing decisions.
How should rations be adjusted when maize silage dry matter is above 35%?
When maize silage DM exceeds 35%, nutritionists should consider: (1) Increase water addition — adding water to the total mixed ration (TMR) to compensate for the lower moisture in the silage and maintain target TMR DM at 42–48%; (2) Reduce inclusion rate if the silage DM means ME is concentrated (check ME/kg fresh weight vs target); (3) Monitor aerobic stability carefully — dry maize ferments less thoroughly; the clamp face should be advanced quickly once feeding begins (minimum 15 cm/day on large clamps); (4) Sample and analyse — request a full NIRS analysis including NDF digestibility (NDFD) and starch digestibility; high DM maize may have reduced starch digestibility due to dry grain processing; (5) Consider acid additive or inoculant on face protection if heating is observed. AHDB Dairy ↗ publishes monthly forage quality data. See the maize DM forecast 2028 article.
Does high starch in maize silage require any feeding management changes?
Above-target starch (>35% DM) increases the risk of rumen acidosis in dairy cattle if rations are not balanced appropriately: (1) Ensure adequate effective NDF — buffer high starch with long-chop grass silage, straw or hay in the TMR; effective NDF drives cud-chewing and saliva production, buffering rumen pH; (2) Check rumen pH — ideally >6.0 for at least 18 hours/day; use rumen buffer if acidosis risk is elevated; (3) Transition carefully — introduce high-starch maize gradually over 2–3 weeks when replacing lower-starch stocks or previous year's maize; (4) Starch digestibility — newly harvested high-DM maize often has lower digestibility than maize stored for 3–6 months (starch retrogradation during fermentation improves rumen accessibility); do not assume high starch = high digestibility. See the maize nutrition management guide for crop production context affecting grain fill and starch content.
How do I take a representative silage sample for analysis?
Representative sampling is critical — maize silage is highly heterogeneous and single grab samples are unreliable. Best practice: (1) Wait 4–6 weeks after clamp sealing before sampling (fermentation should be substantially complete); (2) Core or grab from the clamp face — take samples from 5–10 points across the face (top, middle, bottom, left, right and centre); (3) Composite sample — blend individual cores/grabs into a single 500 g sample; place in a sealed freezer bag and refrigerate immediately; (4) Submit within 24 hours for NIRS analysis (or freeze if delay expected); (5) Request the full NIRS panel — DM, ME, starch, NDF, NDFD (30h digestibility), crude protein and pH; (6) Repeat sampling every 4–6 weeks during feeding to track quality changes. Use NIFTI ↗ or similar accredited laboratory for analysis.
What caused the unusually high dry matter in eastern England 2028?
The 2028 maize season in eastern England was characterised by a warm, dry August and September — above-average temperatures (mean 2°C above 1991–2020 baseline) and rainfall deficit of 40–60% of normal during the grain fill and maturation period. GDD accumulation was the highest in 10 years across Cambridgeshire, Lincolnshire and Norfolk. The combination of high GDD and dry conditions accelerated both grain fill and whole-plant dry-down — maize crops that were at 28–30% DM in early September had reached 34–38% DM by mid-October, significantly earlier than many farms had planned to harvest. Crops left standing beyond mid-October to reach traditional harvest timing were substantially over-dry by collection. The maize DM forecast 2028 article tracked GDD accumulation during the season and the growing degree days glossary entry explains the underlying crop development model.